smilpdev8001.sharpnet.sdac¶

Pre-requisites¶

Installation¶

Install the system using PXE Boot¶

Configuration¶

Configure the system with Ansible¶

Info

During the first boot it take some time for the system to apply all the settings we requested. Before we do anything else make sure the cloud-init finished the setup.

Preparation¶

Before we can run the playbook make sure that the password we choose during the install matches the one in the password vault.

ansible-vault edit vault.yml

vault.yml

...
smilpdev8001_become_password: "Password choosen during install"
...

Run the initial SharpNET deployment role¶

Info

If you see an error message about the Host key make sure to delete the old host key with ssh-keygen, then add the new Host key by logging to the system via SSH.

ssh-keygen -f ~/.ssh/known_hosts -R "smilpdev8001.sharpnet.sdac"
ssh-keyscan -H "smilpdev8001.sharpnet.sdac" >> ~/.ssh/known_hosts

Warning

This playbook usually runs for a long time. On average the execution takes between 20-25 minutes.

ansible-playbook -i inventory.yml sharpnet.deployment.fresh_system \
-e shncmd_target_host=smilpdev8001.sharpnet.sdac -e shncfg_reboot=true